There's no easy way to check an STL's real size in mm before printing

Built!

Do your modeling in your usual software. Check the real size in mm and fix the file quickly, right before printing.

Current workflow

An STL file by itself does not tell you how big the model actually is in millimeters. STL files carry no unit information, so you cannot even tell whether the dimensions were authored in inches or millimeters. In practice, checking the size means loading the file into a slicer or reopening the modeling program, and that is also the first moment you find out whether it fits the build plate. Changing the size means going back to the original program and exporting again, so a simple last-minute check turns into a round trip.

Solution

Measure STL File Size

How to use

1. Load an STL file and the 3D preview appears with its real size in millimeters. 2. Check the width, depth, and height, and scale to the size you want. 3. Rotate the model and set the bottom face. 4. If it is larger than the build plate, cut it along a plane. 5. Check the mesh, then download the fixed STL.

Example

- All figures below are example values chosen to show how the display works, not measurements of a real file. - Input: an STL with only a preview and empty dimension fields ("Width — / Depth — / Height —"), no unit information, and no way to tell whether it fits a build plate (e.g. 220×220mm) - Result (example values): measured dimensions are shown as 84.2mm wide × 52.0mm deep × 31.5mm high. Raising the scale from 100% to 150% updates them to 126.3 × 78.0 × 47.3mm. For a file assumed to be in inches, the original 3.31 × 2.05 × 1.24 in is shown alongside its millimeter conversion.

Open tool
View details
Limits
- STL files carry no unit information. If a file was made in inches, switch the unit to see its size in mm. - No slicing or support generation. Use your usual slicer for that — this tool covers the step right before it. - Complex mesh repair is out of scope. Basic checks and simple repairs are covered; badly broken files need a dedicated repair tool.
Cost type
Free

This tool's scope ends at checking and adjusting size right before printing. It does not slice or generate supports, which are what ultimately decide print quality, so final print preparation still happens in your slicer. Also note that the numbers in this text and in the tool page's example are example values chosen to show how the display works, not measurements of a real file — your model's actual size is the value shown when you load your own file.

Support

I have this problem too · 0 people

Sign in to support or ask a question

Comments

Be the first to comment.

Additional information

Delete a post made without signing in